Editing List of add-ons by EarthMoon
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| − | + | A '''HANGAR''' is an object which can be used to make structures on or near a base. It consists of four sides, and a roof shaped sorta like a barrel where the curved roof slopes to the sides and is about half the total height of the structure. | |
| − | + | ==Textures== | |
| − | + | Any texture listed in the file '''Orbiter\config\base.cfg''' can be used for the textures on a Hangar (See the gallery in the article '''[[Block]]'''. Orbiter's description for how to build objects is located in '''Orbiter\Doc\OrbiterConfig.pdf'''. | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | [[ | + | Open the Bonneville.cfg file ('''Orbiter\Config\Earth\Base\Bonneville.cfg''') and replace the BLOCK that's there with the following. |
| − | [[ | + | |
| − | + | <code> | |
| + | HANGAR | ||
| + | POS 0 0 -50 | ||
| + | SCALE 1 1 1 | ||
| + | ROT 10 | ||
| + | TEX1 Roof01 1 1 | ||
| + | TEX2 Roof01 1 1 | ||
| + | TEX3 Roof02 1 1 | ||
| + | END | ||
| + | </code> | ||
| + | |||
| + | Then launch Orbiter into any scenario. Orbiter will read this .cfg file and create Bonneville base with this Hangar. It should look like this. | ||
| + | [[Image:Hangar_Roof01_Day.png|200px|thumb|center|Image of a HANGAR using Roof01 texture.]] | ||
| + | |||
| + | As described in the [[Block]] article, POS is the position in meters from the center of the base, North- or South+, elevation + or - from the ground, and East+ or West-. SCALE is the size of the Hangar left to right, height, and front to back. ROT is rotation of the object in degrees, clockwise from East. TEX1 (front and rear), TEX2 (sides), and TEX3 (roof) describes which texture to use from the Orbiter\Config|Base.cfg file, then how many times that texture is repeated on that face. | ||
| + | |||
| + | To see all the textures used on objects see the gallery section of the [[Block]] article. | ||
| + | |||
| + | ==Gallery== | ||
| + | <gallery mode=nolines class="center"> | ||
| + | Image:Hangar_Roof01_Day.png|200px|thumb|center|Image of a HANGAR using Roof01 texture. | ||
| + | Image:Hangar_Roof01_TexX5.png|200px|thumb|center|Hangar with Roof01 on the front, Scale is 10 5 15. TEX1 and TEX2 is Roof01 5 1. Note 5 times as many ribs on the width of the front face. | ||
| + | </gallery> | ||