Editing heads up display
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| − | In | + | In Orbiter, the heads-up display is a standard feature of all spacecraft. It has three modes, cycled by pressing the H key; it can also be turned off completely with ctrl-H. |
| − | + | * General information | |
| − | All HUDs show the current time and camera information in the top right-hand corner. In non-panel modes, they also show engine and | + | All HUDs show the current time and camera information in the top right-hand corner. In non-panel modes, they also show engine and RCS status in the top left-hand corner. |
| − | + | * Surface mode | |
| − | The HUD displays a pitch ladder and a cross-in-circle indicator of the current | + | The HUD displays a pitch ladder and a cross-in-circle indicator of the current velocity. (If this overlays the ground, it indicates your projected landing point.) At the top of the HUD is a bearing indicator; this is centred on the vessel's current heading. If a base has been selected in the [[Map MFD]], the direction to that base will be shown as a triangle, either overlaying the bearing strip or pointing off to one side of it. Airspeed and altitude are also shown. |
| − | + | * Docking mode | |
| − | This mode displays direction and velocity relative to the selected docking target (normally chosen with a nav radio). A box surrounds the target (or a triangular pointer shows the way); a cross shows your velocity vector | + | This mode displays direction and velocity relative to the selected docking target (normally chosen with a nav radio). A box surrounds the target (or a triangular pointer shows the way); a cross-in-circle shows your velocity vector, and a cross shows the opposite vector. You can change the reference navigation radio with ctrl-R (which will also cycle through other docking modes; see the manual). |
| − | If you want to match velocity with the target, apply thrust towards the | + | If you want to match velocity with the target, apply thrust towards the cross. |
| − | If the reference radio is tuned to an [[IDS]] transmitter, the HUD will show a series of rectangles aligned with the approach course for the docking | + | If the reference radio is tuned to an [[IDS]] transmitter, the HUD will show a series of rectangles aligned with the approach course for the docking port. |
| − | + | * Orbit mode | |
This mode displays a pitch ladder relative to the current orbital plane, where the zero line indicates the orbital plane. It also marks the [[prograde]] direction with a cross-in-circle and the [[retrograde]] direction by with a cross. (If neither of these is on screen, a triangular marker points towards [[prograde]]. You can change the reference object with ctrl-R. | This mode displays a pitch ladder relative to the current orbital plane, where the zero line indicates the orbital plane. It also marks the [[prograde]] direction with a cross-in-circle and the [[retrograde]] direction by with a cross. (If neither of these is on screen, a triangular marker points towards [[prograde]]. You can change the reference object with ctrl-R. | ||
| − | |||
| − | + | See also: http://en.wikipedia.org/wiki/Heads-Up_Display | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||