Editing COMNAV MFD
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| − | '''COMNAV''' MFD is an | + | '''COMNAV''' MFD is an MFD mode which allows control of the ship's navigation receivers which provides data to various other MFD modes and navigation instruments. With COMNAV, the pilot may select the frequency for each receiver. The text for the active receiver is yellow. The receiver can detect transponder signals from other vessels, bases, landing pads, the ILS transponders for runways, and VOR transmitters. Select COMNAV MFD mode by selecting it in the desired MFD mode selection page. |
| + | |||
| − | |||
Selection options: | Selection options: | ||
| Line 13: | Line 13: | ||
|- | |- | ||
!SL+ | !SL+ | ||
| − | |Shift | + | |Shift + |
|Select next NAV Receiver | |Select next NAV Receiver | ||
|- | |- | ||
!< | !< | ||
| − | |Shift | + | |Shift < |
|Step down frequency by 1 MHz | |Step down frequency by 1 MHz | ||
|- | |- | ||
!<< | !<< | ||
| − | |Shift | + | |Shift = |
|Step up frequency by 1 MHz | |Step up frequency by 1 MHz | ||
|- | |- | ||
| Line 42: | Line 42: | ||
The display in the MFD contains two sections: | The display in the MFD contains two sections: | ||
| − | *The NAV receivers NAV1 through NAV4, which lists the frequency of navigation radios | + | *The NAV receivers NAV1 through NAV4, which lists the frequency of navigation radios. |
| − | + | *Transponder status, which shows the ship's transponder transmitting frequency. | |
| − | *Transponder status, which shows the ship's transponder transmitting frequency | ||
*The frequency of the transmitter and receivers can be changed in increments of 1 MHz and 0.05 MHz using the buttons or hot keys in accordance with the table above from 85 MHz to 140 MHz or by scanning for active signals within that range. If there is an active signal received, the display will indicate data about the source. | *The frequency of the transmitter and receivers can be changed in increments of 1 MHz and 0.05 MHz using the buttons or hot keys in accordance with the table above from 85 MHz to 140 MHz or by scanning for active signals within that range. If there is an active signal received, the display will indicate data about the source. | ||
| Line 50: | Line 49: | ||
*Some MFD modes can be slaved to the NAV receiver to indicate data or used with an autopilot. | *Some MFD modes can be slaved to the NAV receiver to indicate data or used with an autopilot. | ||
| − | *Object Info (Ctrl+ | + | *Object Info (Ctrl+|), Navaid info (CTRL+N), and Map MFD mode can be used to get frequencies for transmitters within range such as VOR and ILS beacons and vessel transponders. |
| − | + | * | |
| − | |||